Mazda CX-5 Service & Repair Manual: Driveline/Axle SST
Front and Rear Axle
|
49 T028 3A0 Ball joint puller set |
|
49 T028 301 Dust boot installer |
|
49 U034 204 Dust boot installer |
|
|
49 W032 310 Support block |
|
— |
— |
||
Drive Shaft
|
49 B025 017 Sliding hammer |
|
49 B025 010 Attachment A |
|
49 H027 002 Bearing remover |
|
|
49 W032 310 Support block |
|
49 T025 001 Boot clamp crimpers |
|
49 UB71 525 Bearing installer |
|
Differential
|
49 D028 203 Support block |
|
49 W034 201 Dust boot installer |
|
49 0107 680A Engine stand |
|
|
49 L027 0A2 Diff hanger set |
|
49 T032 317 Weight |
|
49 T032 316 Shaft |
|
|
49 L027 004 Gear case remover |
|
49 L027 006 Serrate socket |
|
49 L027 007 Hex socket |
|
|
49 H027 002 Bearing remover |
|
49 0839 425C Bearing puller set |
|
49 F401 331 Bearing installer body |
|
|
49 G030 338 Attachment E |
|
49 M005 797 Oil seal installer |
|
49 L025 002 Bearing installer |
|
|
49 F027 007 Attachment o 72 |
|
49 V001 525 Bearing installer |
|
49 B032 335A Oil seal installer |
|
Transfer
|
49 T034 201A Dust boot installer |
|
49 V001 795 Oil seal installer |
|
49 F034 201 Dust boot installer |
|
|
49 F019 001 Oil seal installer |
|
— |
— |
||
Driveline/Axle Features
Improved driveability
Bell-shaped constant velocity joint adopted for wheel-side joint
of front and rear drive shaft
Tripod-shaped constant velocit ...
General Procedures (Front And Rear Axles)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
108—147 N ...
Other materials:
Low Engine Coolant Temperature Indicator Light (Blue)/High Engine Coolant Temperature
Warning Light (Red)
Purpose
Low engine coolant temperature indicator light (blue)
The low engine coolant temperature indicator light (blue) notifies the driver
that the engine coolant temperature is low and vaporization of the fuel is difficult.
High engine coolant temperature warning light (red)
...
Coupling Component Calibration Data Writing
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the toolbox
of the M-MDS.
Select “Chassis”.
3. Then, select items from the screen menu in the following order.
Select “4WD/AWD”.
Select “Coupling Calibra ...
Passenger Side Air Bag Module [Two Step Deployment Control System]
Purpose
When the passenger-side air bag module receives an impact from a frontal
or frontal offset collision, the operation (deployment) of the air bag mediates
the impact to the head and face of the front passenger.
Function
When the passenger-side air bag module receives ...
