Mazda CX-5 Service & Repair Manual: Crankshaft Position (CKP) Sensor
Purpose/Function
-
Detects the crankshaft speed as basic information for mainly determining the fuel injection timing and ignition timing.
-
Detects the crankshaft speed and inputs it to the PCM as a CKP signal.
Construction
-
Installed on the side of the cylinder block (right side).
-
An MR (Magnetic Resistance) element has been adopted as the detecting element for detecting the crankshaft speed.
Operation
-
Inputs the signal, which fluctuates according to the crankshaft speed, to the PCM.
CKP sensor characteristic
Fail-safe
|
DTC No. |
Fail-safe function |
|
P0335:00 |
|
Crankshaft Position (CKP) Sensor Removal/Installation
CAUTION:
When foreign material such as an iron chip is on the CKP sensor, it can cause
abnormal output from the sensor because of flux turbulence and adversely affect
the engine control. ...
Crankshaft, Main Bearing
Purpose, Function
The crankshaft converts the reciprocating movement of the piston to a rotational
movement via the connecting rod.
The main bearing forms an oil film on the outer su ...
Other materials:
Fuel System
Purpose, Outline
A multiple hole type fuel injector has been adopted which provides higher
fuel injection accuracy for improved fuel efficiency and output.
Piston movement-compression by the 4-head cam inside the high pressure fuel
pump heightens the fuel pressure, achieving imp ...
Oil Seal (Side Gear) Replacement
1. Remove the drain plug and the drain differential oil into a container.
2. Install a new washer and the drain plug, and tighten.
3. Remove the rear drive shaft..
4. Remove the clip from the drive shaft.
CAUTION:
Wrap the end of a screwdriver with cloth to prevent scratches to the i ...
Rear Body Control Module (Rbcm) Configuration (Using As Built Data)
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
