Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: ABS Wheel Speed Sensor And ABS Sensor Rotor

Purpose/Function

Construction

*: A magneto-resistive force means that an exterior magnetic field acts on the element, changing the resistance of the element.

CAUTION:

NOTE:

Front ABS wheel-speed sensor and sensor rotor


Rear ABS wheel-speed sensor and sensor rotor (2WD)


Rear ABS wheel-speed sensor and sensor rotor (AWD)


Operation


Fail-safe


DTC No.

Fail-safe function

C0030:07

  • Illuminates the ABS warning light and TCS/DSC indicator light.

  • Tire pressure monitoring system warning light illuminates after flashes.

  • Inhibits the ABS, TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS controls.

    (Additionally, when any malfunction is detected in two wheels or more, EBD control is inhibited and the brake system warning light is illuminated.)

C0031:07

C0031:11

C0031:15

C0031:29

C0031:2F

C0031:64

C0033:07

C0034:07

C0034:11

C0034:15

C0034:29

C0034:2F

C0034:64

C0036:07

C0037:07

C0037:11

C0037:15

C0037:29

C0037:2F

C0037:64

C0039:07

C003A:07

C003A:11

C003A:15

C003A:29

C003A:2F

C003A:64


Sensors, Switches, Relays
...

Front ABS Wheel Speed Sensor Inspection
Sensor Output Value Inspection CAUTION: Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the A ...

Other materials:

Towing
Trailer Towing (U.S.A. and Canada) Your Mazda was designed and built primarily to carry passengers and cargo. If you tow a trailer, follow these instructions because driver and passenger safety depends on proper equipment and safe driving habits. Towing a trailer will affect handling, braking, ...

Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge. 2. Verify the clearance. If not within the specification, remove the pressure plate and adjust the clearance by changing the shim (0.2 mm {0.008 i ...

On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL, Fw6 Ax EL]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “TCM”. 3. Select the applicable PID from the PID table. 4. Verify the PID da ...

© 2016-2019 Copyright www.mcx5.org