Mazda CX-5 Service & Repair Manual: Wheel Hub, Steering Knuckle Inspection
Wheel Bearing Excessive Play Inspection
1. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play.
-
If it exceeds the maximum specification, replace the wheel hub bearing.
-
Front wheel bearing maximum play
-
0.05 mm {0.002 in}
Front Wheel Hub Bolt Replacement
1. Remove the brake calliper component from the steering knuckle and suspend
it out of the way using a cable.
2. Remove the disc plate.
3. Remove the wheel hub bolt using the SST as shown in the ...
Wheel Hub, Steering Knuckle Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Befo ...
Other materials:
Master Cylinder Removal/Installation
1. Remove the battery..
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, add brake fluid, bleed the air, and inspect for fluid
leakage..
1
Brake fluid level sensor connector
2
...
Interior Equipment (View A)
1 Door-lock knob
2 TCS OFF switch
3 Tire pressure monitoring system set switch
4 Turn and lane-change signal
5 Lighting control
6 Instrument cluster
7 Dashboard illumination knob
8 Wiper and washer lever
9 Push button start
10 AFS OFF switch
11 BSM OFF switch
12 Outside mirror ...
Rear Door Trim Disassembly/Assembly
1. Disassemble in the order shown in the figure.
1
Switch panel cover
2
Power window subswitch.
3
Fastener
4
Rear door trim
2. Assemble in the reverse order of disassembly.
...
