Mazda CX-5 Service & Repair Manual: Suspension

Rear Wheel Hub Bolt Replacement

1. Remove the brake calliper component and suspend it out of the way using a cable. 2. Remove the disc plate. 3. Remove the wheel hub bolt using the SST as shown in the figure. 4. Place ...

Suspension Abbreviations

AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC Access ...

Other materials:

Throttle Position (TP) Sensor Inspection
Voltage Inspection CAUTION: The inspection cannot be performed with this method correctly if there is a malfunction of the APP sensor or throttle valve actuator. Verify that no DTCs related to the APP sensor or throttle valve actuator are stored before the inspection. NOTE: ...

Front Drive Shaft Inspection
1. Inspect the connections for any looseness. If there is any malfunction, tighten or replace the applicable part. 2. Inspect the dust boot for damage and cracks. If there is any malfunction, replace the applicable part. 3. Move the spline and joint up and down, left ...

When Liftgate Cannot be Opened
When Liftgate Cannot be Opened If the vehicle battery is dead or there is a malfunction in the electrical system and the liftgate can not be opened, perform the following procedure as an emergency measure to Open it: 1. Remove the cap on the interior surface of the liftgate with a flathead sc ...