Outline
Front seat
A manual seat or power seat has been adopted on the driver's seat.
A seat warmer system has been adopted on the front seats. (with seat warmer system)
A manual seat has been adopted on the front passenger's seat.
A side air bag module is built into the front seats.
S-shaped springs have been adopted in the front seat cushions.
Rear seat
6:4 split type or 4:2:4 split type seats have been adopted on the rear seats.
A center armrest has been adopted on the 4:2:4 split-type rear seat's center seat.
Large-sized cup holders have been adopted on the center armrest.
The following two types of child restraint seat anchors have been adopted which enable securing of ISO FIX-applicable child restraint seats on the rear seat.
Top tether anchor
ISO FIX anchor
Structural view

Remote Handle Lever Removal/Installation
Seat Track Position Sensor Removal/Installation [Two Step Deployment Control
System]Room Straight Line Dimensions (3) [Dimensions]
Point symbol
Designation
Hole diameter or bolt or nut size mm {in}
A
Rear seat installation hole
?14 {0.55}
B
D-pillar trim installation hole
?8.6 {0.34}
...
PID/Data Monitor Inspection [Two Step Deployment Control System]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “RCM”.
3. Select the applicable PID from the PID table.
4. Verify the PID da ...
Back Up Light Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Remove the front under cover No.2..
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
1
Back-up light switch connector
2
Back-up light switch
...