Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Roof Molding Removal

1. Insert a tape-wrapped flathead screwdriver in the position shown in the figure.

2. Rotate a tape-wrapped flathead screwdriver in the direction of the arrow in the order of (1), (2) shown in the figure and remove the roof molding from the front T-stud.


3. Rotate the roof molding in the direction of the arrow (3) shown in the figure, pull up the roof molding in the direction of the arrow (4) while detaching it from clips and protector, rear T-stud and then remove the roof molding.

Roof Molding Installation
1. Install the roof molding to the front T-studs. 2. Hook the roof molding to clips and attach the roof molding while pressing it in the direction of the arrow shown in the figure. 3. Instal ...

Seats
...

Other materials:

Registering Your Vehicle in A Foreign Country (Except United States and Canada)
Registering your vehicle in a foreign country may be problematic depending on whether it meets the specific emission and safety standards of the country in which the vehicle will be driven. Consequently, your vehicle may require modifications at personal expense in order to meet the regulation ...

Rear Door Garnish Removal/Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. Front 1. Using a tape-wrapped fastener remover, remove clips A in the direction of arrow (1), (2) shown in the figure. 2. Remove the double-sided adhesive tape in the ...

Hazard Warning Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the decoration panel.. 3. Verify that the continuity between the hazard warning switch terminals is as indicated in the table. If the continuity is as indicated in the table, go to the next step. If not as indicated i ...

© 2016-2026 Copyright www.mcx5.org