Mazda CX-5 Service & Repair Manual: Rear Axle Assembly

Front Axle

Purpose, Function An angular ball bearing, with a low rotational resistance, has been adopted, improving driveability. A unit bearing that does not require pre-load setting has been ...

Rear Axle

Purpose, Function An angular ball bearing, with a low rotational resistance, has been adopted, improving driveability. A unit bearing that does not require pre-load setting has been ...

Other materials:

Audio Pilot®2 Microphone Removal/Installation
NOTE: AudioPilot®2 is a registered trademark of Bose® Corporation. 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). ...

Rear Wheel Hub Bolt Replacement
1. Remove the brake calliper component and suspend it out of the way using a cable. 2. Remove the disc plate. 3. Remove the wheel hub bolt using the SST as shown in the figure. 4. Place a new wheel hub bolt in the wheel hub. 5. Install the wheel hub by placing a proper sized washer o ...

Start Stop Unit Configuration (Using As Built Data)
NOTE: If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the set value with the customer and perform the personalization function setting after performing th ...