Mazda CX-5 Service & Repair Manual: Mass Air Flow (MAF) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Intake / Mass Air Flow (MAF) Sensor

Purpose/Function

Detects the intake airflow amount introduced into the cylinder as basic information for mainly determining the fuel injection amount.
Detects the intake airflow amount introduced into the cylinder and inputs it to the PCM as an intake airflow amount signal.

Construction

Installed on the air cleaner.
A hot film has been adopted as the detecting element for detecting the intake airflow amount.
IAT sensor No.1 is integrated.

Operation

Inputs the signal, which fluctuates according to the intake airflow amount, to the PCM.

MAF sensor characteristic

Fail-safe


DTC No.	Fail-safe function
P0102:00	Restricts the upper limit of the engine speed. Inhibits the evaporative purge control.
P0103:00	Restricts the upper limit of the engine speed. Inhibits the evaporative purge control.

Mass Air Flow (MAF) Sensor Inspection

Visual Inspection 1. Remove the MAF sensor/IAT sensor No.1.. 2. Visually inspect the MAF sensor for the following: Damage, cracks, soiling Rusted sensor terminal Bent sensor ...

Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation

NOTE: Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1. 1. Disconnect the negative bat ...

Other materials:

Receiver/Drier Removal/Installation
1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Remove the front under cover No.1.. 4. Drain the engine coolant.. 5. Remove the following parts: a. Plug hole plate. b. Air cleaner, air hose and fresh air duct component. c. Coolant reserve tank. d. Cooling ...

PID/Data Monitor Inspection [Standard Deployment Control System]
1. Connect the M-MDS to the DLC?2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “RCM”. 3. Select the applicable PID from the PID table. 4. Verify the PID da ...

Clock Spring Adjustment [Standard Deployment Control System]
1. Set the front wheels straight ahead. CAUTION: The clock spring will break if over?wound. Do not forcibly turn the clock spring. 2. Turn the clock spring clockwise until it stops. 3. Turn the clock spring counterclockwise approx. 2 turns. 4. Align the mark on the clo ...