Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: License Plate Light

Purpose

Function

Construction


Operation

1. When the light switch is operated to the TNS position, a TNS signal is input to the start stop unit.

2. The start stop unit sends the TNS signal to the front body control module (FBCM).

3. When the front body control module (FBCM) receives the TNS signal, it turns the TNS relay on.

4. When the TNS relay turns on, the license plate bulbs are illuminated.


Fail-safe

High Mount Brake Light Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the liftgate upper trim.. 3. Remove the rear spoiler.. 4. Disconnect the connector. 5. While pressing the high-mount brake light tab in ...

License Plate Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the clearance between the lens and license plate light shown in the figure. 3. Move the flathead ...

Other materials:

Main Fuse Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull up the main fuse cover in the direction of the ...

Starter Cut Off Control [Skyactiv G 2.0]
Outline The PCM controls energization to the starter relay according to an immobilizer system request to improve security. While not in P or N position, the starter relay energization by the ignition key is inhibited. (ATX) While not in neutral, the starter relay energiz ...

Driver Side Air Bag Module [Standard Deployment Control System]
Purpose When the driver-side air bag module receives an impact from a frontal or frontal offset collision, the operation (deployment) of the air bag mediates the impact to the head and face of the driver. Function When the driver-side air bag module receives an impact from ...

© 2016-2026 Copyright www.mcx5.org