Pictorial Index
Interior Equipment (View A)Tie Rod End Inspection
1. Inspect the tie-rod end for damage and the boot for cracks.
If there is any malfunction, replace the tie-rod end.
2. Inspect for excessive play.
If there is any malfunction, replace the tie-rod end.
3. Rotate the tie-rod end five times.
4. Install two nuts to the ba ...
Vacuum Pump Inspection
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the
vacuum pump..
2. Install the vacuum gauge as shown in the figure, then check the vacuum.
3. Warn up the engine.
If the pressure is less than the specification, inspect for the following.
Malf ...
Mechanical
Outline
The sliding resistance*1 has been reduced by:
the adoption of a rocker arm (built into needle roller bearing)
reducing load on the valve spring
narrowing down the crankshaft journal
optimizing the piston skirt shape
adoption of ...