Mazda CX-5 Service & Repair Manual: Front Tilt Motor Inspection

Mazda CX-5 Service & Repair Manual / Body / Seats / Front Tilt Motor Inspection

WARNING:

Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual before handling the front seat (side air bag integrated)..

CAUTION:

When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean cloth so as not to damage or soil the seat.

NOTE:

When removing the front seat from the vehicle or putting it back in, it can be performed smoothly by removing the headrest.

1. Disconnect the negative battery cable and wait for 1 min

2. Disconnect the front tilt motor connector.

3. Apply battery positive voltage to the front tilt motor terminals and inspect the front seat operation.

If not as specified, replace the front seat cushion frame.(See FRONT SEAT CUSHION FRAME REMOVAL/INSTALLATION.)


Front seat operation	Connection
Front seat operation	B	D
Up	GND	B+
Down	B+	GND

Front Seat Side Cover Removal/Installation

WARNING: Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings in the Workshop Manual before handlin ...

Lift Motor Inspection

WARNING: Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual befor ...

Other materials:

Exhaust System Removal/Installation
WARNING: A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system. 2WD 1. Disconnect the negative battery cable.. 2. Remove in the order indicated in the table. 3. Remove the insulator.. 4. Ins ...

Outside the United States/Canada
Government regulations in the United States/Canada require that automobiles meet specific emission regulations and safety standards. Therefore, vehicles built for use in the United States/Canada may differ from those sold in other countries. The differences may make it difficult or even impossi ...

Airflow Mode Actuator [Full Auto Air Conditioner]
Purpose The airflow mode actuator moves the mode door in the A/C unit to switch the air vent. Function Door open/close function The airflow mode actuator drives the motor based on the signal from the climate control unit and moves the mode door to the VENT, BI-LEVEL, HEAT, ...