Mazda CX-5 Service & Repair Manual: Front Axle Assembly

Rear Drive Shaft Removal/Installation

CAUTION: Performing the following procedures without first removing the ABS wheel?speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before perfor ...

Front Axle

Purpose, Function An angular ball bearing, with a low rotational resistance, has been adopted, improving driveability. A unit bearing that does not require pre-load setting has been ...

Other materials:

Washer Fluid Level Sensor Inspection
1. Disconnect the negative battery cable.. 2. Set the front over fender aside.. 3. Set the mudguard (RH) aside.. 4. Remove the front bumper.. 5. Inspect for continuity according to washer fluid level between the washer fluid-level sensor terminals. If not as indicated in th ...

Tires
For reasons of proper performance, safety, and better fuel economy, always maintain recommended tire inflation pressures and stay within the recommended load limits and weight distribution. WARNING Using Different Tire Types: Driving your vehicle with different types of tires is dangerous. It ...

Oil Seal (Coupling Component) Replacement
1. Drain the differential oil into a container. 2. Remove the coupling component.. 3. Remove the oil seal from the differential carrier using a screwdriver or similar tool. 4. Apply differential oil to the new oil seal lip. 5. Install the new oil seal to the differential carrier using the ...