Mazda CX-5 Owners Manual: Fog Lights
Use this switch to turn on the fog lights.
The fog lights will improve visibility at night and during foggy conditions.
To turn the fog lights on, rotate the fog light switch to the
position.
The headlight switch must be in the
position before turning on the fog lights.
To turn the fog lights off, rotate the fog light switch to the
position or turn the headlight switch
to the 
or
position.
NOTE
• The fog lights will turn off when the headlights are set at high beams.
• (With auto-light control)
If the fog light switch is in the 
position
and the headlight switch is in the 
position, the fog lights will turn on when the headlights, the exterior lights and
dashboard illumination turn on.
Lighting Control
Headlights
• Turn the headlight switch to turn the headlights,
other exterior lights and dashboard illumination on or off.
• A system malfunction or operation conditions
are indicated by a w ...
Turn and Lane-Change Signals
NOTE
• If an indicator light stays on without
flashing or if it flashes abnormally, one of the turn signal bulbs may be burned
out.
• A personalized function is available to change
the tur ...
Other materials:
Brake/Clutch Fluid
Inspecting Brake/Clutch Fluid Level
The brakes and clutch draw fluid from the same reservoir.
Inspect the fluid level in the reservoir regularly. It should be kept at MAX.
The level normally drops with accumulated distance, a condition associated with
wear of brake and clutch linings. If it is ...
Liftgate Side Trim Removal/Installation
1. Remove the liftgate upper trim..
2. Remove the fastener A.
3. Take the shaded area shown in the figure, and pull the liftgate side trim
in the direction of the arrow (1) while detaching clips B.
4. Take the shaded area shown in the figure, detach tabs C while pulling the
liftgate si ...
Heated Oxygen Sensor (HO2 S) Removal/Installation
WARNING:
A hot engine and exhaust system can cause severe burns. Turn off the engine
and wait until they are cool before removing the exhaust system.
CAUTION:
Do not allow flammable objects such as the taping for bundling wiring harness
to come into contact with the exhau ...
