Mazda CX-5 Service & Repair Manual: Cruise Control

Accessories

...

Cruise Control Switch Inspection

1. Disconnect the negative battery cable and wait for 1 min or more.. 2. Remove the driver?side air bag module.. 3. Disconnect the clock spring connector (part wiring harness-side). 4. Measure ...

Other materials:

Side Step Molding Removal/Installation
1. Set the rear over fender aside.. 2. Insert a tape-wrapped flathead screwdriver shown in the figure and remove the clip A in the direction of arrow (1). 3. Slide the side step molding in the direction of the arrow (2) shown in the figure and remove clips B from side step molding. 4. ...

Rear Crossmember Removal/Installation [2 Wd]
WARNING: Verify that the rear crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle. CAUTION: Performing the following procedures without first removing the rear ABS wheel-speed s ...

Blind Spot Monitoring (Bsm) Control Module Inspection
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Connect the negative battery cable.. 5. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference). If the voltage is n ...