Mazda CX-5 Service & Repair Manual: Control System [Manual Air Conditioner]
Outline
-
Refrigerant pressure sensor adopted in which refrigerant pressure is changed into a linear electric signal and precise information is transmitted.
-
Climate control unit with enlarged operation dials and switches adopted
Structural View
System Wiring Diagram
Control System [Full Auto Air Conditioner]
Outline
Refrigerant pressure sensor adopted in which refrigerant pressure is changed
into a linear electric signal and precise information is transmitted.
MS-CAN for communicatio ...
Drive Belt Inspection [Skyactiv G 2.0]
Generator Drive Belt
NOTE:
The generator drive belt deflection/tension inspection is not necessary with
the adoption of the drive belt auto tensioner.
1. Verify that the indicator pa ...
Other materials:
Map Light Removal/Installation
Front Map Light
1. Disconnect the negative battery cable..
2. Open the sunglasses holder.
3. Remove the screws from the front map light.
4. Move the front map light in the direction of the arrow (1) shown in the figure
and pull out the pin from the bracket.
CAUTION:
Be careful ...
Heater Hose Removal/Installation
With Water Temperature Sensor
1. Remove the battery..
2. Drain the engine coolant..
3. Remove the insulator.
4. Remove the clips and remove the heater hose.
5. Remove the heater hose.
6. Install in the reverse order of the removal.
7. Inspect for engine coolant leaka ...
Rear Window Wiper and Washer
The ignition must be switched ON.
Rear WindowWiper
Turn the wiper on by turning the rear wiper/washer switch.
Rear WindowWasher
To spray washer fluid, turn the rear wiper/ washer switch to the
position. After the switch is released,
the washer will stop.
If the washer does not work, ins ...
