Mazda CX-5 Service & Repair Manual: Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable..
2. Remove the glove compartment..
3. Disconnect the air intake actuator connector.
4. Remove the screw, then remove the air intake actuator.
5. Install in the reverse order of removal.
Air Intake Actuator Inspection [Manual Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C),
connect terminal C (or B) to ground, and then verify that the air intake actuator
operates as shown in the table.
...
Air Intake Actuator Removal/Installation [Manual Air Conditioner]
1. Disconnect the negative battery cable..
2. Remove the glove compartment..
3. Disconnect the air intake actuator connector.
4. Remove the screw, then remove the air intake actuator.
5. I ...
Other materials:
Brake/Clutch Fluid
Inspecting Brake/Clutch Fluid Level
The brakes and clutch draw fluid from the same reservoir.
Inspect the fluid level in the reservoir regularly. It should be kept at MAX.
The level normally drops with accumulated distance, a condition associated with
wear of brake and clutch linings. If it is ...
Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air
Conditioner]
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (driver-side).
b. Front side trim (driver-side).
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX).
f. Front console box.
g. Shift panel.
h. Upper panel.
i. Rear console. ...
Procedure [Plastic Body Parts]
Repair of polypropylene bumpers having damage that has reached the surface of
the polypropylene and are too serious to be restored by painting only.
1. Cut the rough edges around the damage with a knife to make it smooth. Sand
the area with a sander to make an angle of about 45°.
2. ...
