Mazda CX-5 Service & Repair Manual: Air Cleaner Element Inspection
1. Remove the air cleaner element..
2. Inspect the following items:
-
Has the replacement interval past?
-
Is the air cleaner element soiled, damaged, or bent?
-
Are the air cleaner case and the air cleaner element correctly sealed?
-
Is the correct air cleaner element installed?
-
If there is any abnormality, clean or replace the air cleaner element..
Intake
...
Air Cleaner Element Removal/Installation
1. Remove the air cleaner element as shown in the figure.
2. Install in the reverse order of removal. ...
Other materials:
Bumper Slider Removal/Installation
Front Bumper Slider
1. Disconnect the negative battery cable..
2. Remove the seal board upper..
3. Remove the front bumper..
4. Remove bolts A.
5. Pull the front bumper slider in the direction of the arrow while detaching
pins B and hook C.
6. Install in the reverse order of removal ...
Rear Drive Shaft Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel?speed
sensor may possibly cause an open circuit in the harness if it is pulled by
mistake. Before performing the following procedures, remove the ABS wheel?speed
sensor (wheel side) and fix it to an ...
Tcs Control
Outline
The TCS control actuates torque reduction through engine control, as well
as using brake control to control traction.
NOTE:
Engine control: Engine output is lowered by fuel cut and ignition timing
control to reduce the traction, preventing driving wheel slip.
...
