Mazda CX-5 Service & Repair Manual: Wiper/Washer System Personalization
-
A customize function has been adopted which switches the auto wiper system between operable/inoperable.
Using Mazda Modular Diagnostic System (M-MDS)
-
The auto wiper function can be enabled or disabled using the Mazda Modular Diagnostic System (M-MDS). Refer to the Workshop Manual for the customize function setting procedure.
|
Mazda Modular Diagnostic System (M-MDS) display |
Function |
Initial setting |
Setting contents |
Control module |
|
Rain Sensing Wipers |
Auto wiper system can be set to operable or inoperable. |
On |
Not Adopted / Off (Intermittent) / On (Rain Sensing) |
Rear body control module (RBCM) |
Using Audio Unit (With Color LCD)
-
The user can enable or disable the auto wiper function by operating the audio unit display. Refer to the Workshop Manual for the detailed customize function setting procedure.
|
Audio unit display |
Function |
Initial setting |
Setting contents |
Control module |
|
Wipers |
Auto wiper system can be set to operable or inoperable. |
On (Rain Sensing) |
On (Rain Sensing) / Off (Intermittent) |
Rear body control module (RBCM) |
Wiper/Washer System
Outline
The following wiper/washer system has been adopted.
Windshield wiper system
Rear wiper system
Auto wiper system (with auto wiper system)
Wa ...
Wiper/Washer System Personalization Features Setting Procedure
Using M-MDS
The auto wiper function can be enabled or disabled using the M-MDS. Refer
to the control system personalization features setting..
Using Audio Unit (With Color LCD)
...
Other materials:
A/C Compressor
Purpose
The A/C compressor circulates the refrigerant in the refrigerant cycle.
The A/C compressor compresses the gaseous refrigerant atomized by the evaporator,
and by pressurizing the gaseous refrigerant, liquification by the condenser
is facilitated.
Function
The ...
Extractor Chamber Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear splash shield.
b. Rear combination light.
c. Rear bumper.
3. Insert a tape-wrapped flathead screwdriver shown in the figure and remove
clips in the direction of arrow (1).
4. Remove the extractor cham ...
Blower Unit Disassembly/Assembly
CAUTION:
Apply only the specified grease to the link. Otherwise abnormal noise or
improper operation may result.
1. Disassemble in the order indicated in the table.
1
Air filter
2
Harness
3
Blower ...
