Mazda CX-5 Service & Repair Manual: Windshield Wiper Motor Inspection

Mazda CX-5 Service & Repair Manual / Body / Wipers, Washers / Wipers / Windshield Wiper Motor Inspection

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Windshield wiper arm and blade.

b. Cowl grille.

Windshield Wiper Motor Inspection

1. Apply battery positive voltage and connect the ground to the windshield wiper motor terminals as indicated in the table below and verify the operation condition.


B+	Ground	Windshield wiper motor operation status
A	D	LO
B	D	HI

If not as indicated in the table, replace the windshield wiper motor..

Auto-stop Operation Inspection

1. Connect the battery voltage to windshield wiper motor terminal A, connect the ground to motor terminal D, and operate the windshield wiper motor at low speed.

2. Disconnect the battery voltage from terminal A during windshield wiper LO operation, and stop the windshield wiper motor halfway.

3. Connect windshield wiper motor terminals A and E using a jumper wire.

4. Connect the battery positive voltage to windshield wiper motor terminal C.

5. After the windshield wiper motor auto-stop operation, verify that it stops at the park position.

If there is any malfunction, replace the windshield wiper motor..

Windshield Wiper Motor And Link Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Windshield wiper arm and blade. b. Cowl grille. CAUTION: Always affix protective tape to the windshield end ...

Windshield Wiper System

Outline Equipped with continuous (low/high), auto-stop, one-touch wiper, intermittent wiper (without auto wiper system), auto wiper (with auto wiper system), and synchronized washer and w ...

Other materials:

High Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The high clutch operates in 4GR, 5GR, and 6GR and intermittently operates the rear carrier by drive force from the turbine shaft. For the high clutch, a centrifugal balance clutch has been adopted to prevent clutch drag and to assure stabilized piston thrust in ...

Headlight High Beam Indicator Light
Purpose Notifies the user that the headlights (HI) are illuminated. Function Illuminates when the headlight (HI) or parking illumination conditions are met. Construction Displayed in the instrument cluster. Operation 1. When the light switch is operat ...

Pressure Control Valve Inspection [Skyactiv G 2.0]
1. Remove the pressure control valve assembly.. CAUTION: Do not apply a pressure 36 kPa {0.37 kgf/cm2, 5.2 psi} or more. Doing so will damage the pressure control valve and evaporative hose. 2. Apply a pressure of 36 kPa {0.37 kgf/cm2, 5.2 psi} to port A. 3. Verify that ther ...