Mazda CX-5 Service & Repair Manual: Vacuum Pump Inspection

Mazda CX-5 Service & Repair Manual / Brakes / General / Vacuum Pump Inspection

1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump..

2. Install the vacuum gauge as shown in the figure, then check the vacuum.

3. Warn up the engine.

If the pressure is less than the specification, inspect for the following.

Malfunction of the vacuum pump

Shortage of the lubrication oil pressure

Vacuum pump vacuum specification (reference value)


Measurement condition		Specification
Engine speed	Change in vacuum amount	Period of time change in vacuum amount condition met
While idling (520—700 rpm (reference value))	From 60 kPa {450 mmHg, 18 inHg} to 67 kPa {503 mmHg, 20 inHg}	8 s or less

Vacuum pump maximum vacuum specification (reference value)


Measurement condition	Specification
While idling (no time designation)	93.3 kPa {700 mmHg, 27.6 inHg} or more

4. Install in the reverse order of the removal.

Vacuum Line Inspection

1. Remove the vacuum hose.. 2. Verify that air can be blown from the power brake unit side of the vacuum hose towards the vacuum pump side, and that air cannot be blown in the opposite direction ...

Vacuum Pump Removal/Installation

1. Remove the plug hole plate.. 2. Remove the battery.. 3. Set the PCM wiring harness out of the way. 4. Disconnect the vacuum hose from the vacuum pump.. 5. Remove in the order shown in the t ...

Other materials:

Installing Child-Restraint Systems
Accident statistics reveal that a child is safer in the rear seat. The front passenger's seat is clearly the worst choice for any child under 12, and with rear-facing childrestraint systems it is clearly unsafe due to air bags. NOTE Even if your vehicle is equipped with front passenger sea ...

Power Window Subswitch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the cover A. 3. Insert a tape-wrapped fastener remover shown in the figure and remove the tab B in the direction of arrow (1). 4. Slide the power window subswitch cover in the direction of the arrow (2) shown in the figure and re ...

Clutch Release Cylinder Removal/Installation [C66 M R]
CAUTION: Do not allow clutch fluid to get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely. 1. Remove the front under cover No.2.. ...