Mazda CX-5 Service & Repair Manual: Instrument Cluster Operation Record

Mazda CX-5 Service & Repair Manual / Body / Driver Info & Control / General / Instrument Cluster Operation Record

Purpose

The instrument cluster operation record stores the record of the illumination or flashing of the warning light.

Function

The operation record is stored by the instrument cluster and displayed using the Mazda Modular Diagnostic System (M-MDS).
The instrument cluster stores the following when any of the warning lights illuminates or flashes.

Time and date
Control module which sent warning light illumination/flash request
Battery voltage

Construction

Based on the stored record, the instrument cluster displays the following operation record on the M-MDS screen.

Operation

When the instrument cluster receives a CAN signal or a warning light illumination/flash request signal sent from each switch, it controls the warning light to illuminate/flash and stores the operation record at the same time.

Fail-safe

Function not equipped.

Instrument Cluster Inspection

Speedometer inspection Using a speedometer tester 1. Adjust the tire pressure to the specification. 2. Using a speedometer tester, verify that the tester reading is as indicated in the following ...

Instrument Cluster Operation Record

1. Connect the M-MDS to the DLC-2. 2. After vehicle identification, select the following from the M-MDS initial screen. “Operational Record” 3. Then, select the following from th ...

Other materials:

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]
NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed at MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULATE mode. 4. Turn the A/C switch off. 5. Close all doors and windows. 6. Wait for 5 min. 7 ...

Parking Brake Lever Removal/Installation
1. Remove the front console box.. 2. Remove the shift lever knob. (MTX). 3. Remove the shift panel.. 4. Remove the upper panel.. 5. Remove in the order indicated in the table. 6. Install in the reverse order of removal. 7. After installation, inspect the parking brake lever stroke.. ...

Quick Release Connector (Emission System) Removal/Installation
Quick Release Connector Type and Position CAUTION: Verify the type and location, and install/remove properly. U.S.A. and CANADA Except U.S.A. and CANADA Type A Removal CAUTION: Be careful not to damage the evaporative pipe when unlocking the retainer. NOTE: ...