Mazda CX-5 Service & Repair Manual: Wiper/Washer System
Outline
-
The following wiper/washer system has been adopted.
-
Windshield wiper system
-
Rear wiper system
-
Auto wiper system (with auto wiper system)
-
Washer fluid-level sensor (with washer fluid-level sensor)
Specification
-
Windshield wiper system with continuous (low/high), auto-stop, one-touch wiper, intermittent wiper, and synchronized washer and wiper operation adopted.
-
CAN communication has been adopted for the windshield wiper system.
-
Windshield washer nozzles have been adopted in which the area where the washer fluid is sprayed can be adjusted.
-
Rear wiper system with continuous, auto-stop, intermittent wiper, and synchronized washer and wiper operation adopted.
-
CAN communication has been adopted for the rear wiper system.
-
Rear washer nozzle have been adopted in which the area where the washer fluid is sprayed can be adjusted.
-
An auto wiper system adopted which enables fully automatic windshield wiper operation.
-
CAN communication has been adopted for the auto wiper system.
-
A rain sensor integrated with the lens has been adopted which aggregates infrared light to detect the amount of rainfall.
-
Auto wiper system personalization features has been adopted.
-
A washer fluid-level sensor is installed in the washer tank.
|
Item |
With the washer fluid-level sensor |
Without the washer fluid-level sensor |
|
Washer tank capacity |
4.5 L {4.8 US qt, 4.0 Imp qt} |
2.2 L {2.3 US qt, 1.9 Imp qt} |
System Structural View
Windshield Wiper And Washer Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Column cover.
b. Wiper and washer switch.
3. Use a tester to measure and verify that the continuity between the win ...
Wiper/Washer System Personalization
A customize function has been adopted which switches the auto wiper system
between operable/inoperable.
Using Mazda Modular Diagnostic System (M-MDS)
The auto wiper function can ...
Other materials:
Front Door Speaker Removal/Installation
Without Bose®
NOTE:
If the procedure is performed while holding the front door speaker cone,
it could deform the cone causing a malfunction. Therefore, perform the procedure
while holding any part other than the cone.
1. Disconnect the negative battery cable..
2. Remove the f ...
D Pillar Speaker Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
e. D-pillar trim.
3. Disconnect the connector.
4. Remove the screws.
5. Remove the D-pillar speaker.
6. While pressing the tab ...
Controller Area Network (Can)
Outline
The DSC HU/CM sends and receives data to and from other modules via the CAN
system. Refer to MULTIPLEX COMMUNICATION SYSTEM for a detailed explanation of
the CAN system..
Data sent
Cruise control system-related information
DSC system-related information
...
