Mazda CX-5 Service & Repair Manual: Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum).
-
The output shaft speed sensor detects the rotation speed of the output shaft (primary gear).
-
The turbine/input shaft speed sensor and output shaft speed sensor signals are used for automatic shift control, manual shift control, and the on-board diagnostic system.
Construction
-
The turbine/input shaft speed sensor and output shaft speed sensor are both integrated with the TCM and built-into the control valve body.
Operation
-
The turbine/input shaft speed sensor changes the output signal according to the rotation speed of the low clutch drum.
-
The output shaft speed sensor changes the output signal according to the rotation speed of the primary gear.
Synchronizer Mechanism [C66 M R]
Purpose, Function
For smooth gear changes, the synchronizer mechanism synchronizes the rotation
of the engaging area and engages gears.
Construction
Detent ball-type synchronizer ...
Clutch Cover Inspection [C66 M R]
1. Remove the clutch cover..
2. Perform the following procedures to inspect the clutch cover.
If it exceeds the maximum specification, replace the clutch cover..
a. Measure the wear of ...
Other materials:
Personalization Features
The following systems can be customized.
When performing a customized setting, refer to the referenced section for
the detailed setting procedure.
Security And Locks
NOTE:
There are two types of customization procedures; one using the M-MDS and
the other using the ...
Instrument Cluster Configuration (Using Read/Write Function)
NOTE:
When performing configuration, it is necessary to read the vehicle specification
information from the instrument cluster before replacing it. Connect the M-MDS
to the vehicle and perform vehicle identification before removing the instrument
cluster. The vehicle specification i ...
B Pillar Lower Trim Removal/Installation
1. Remove the front scuff plate..
2. Remove the rear scuff plate..
3. Partially peel back the seaming welt.
4. Take the shaded area shown in the figure, and pull the B-pillar lower trim
in the direction of the arrow in the order of (1), (2) while detaching hooks A,
pins B.
5. Take th ...
