Mazda CX-5 Owners Manual: Tiedown Hooks
CAUTION
Do not use the front and rear tiedown eyelets for towing the vehicle.
They have been designed only for securing the vehicle to a transport vessel during shipping.
Using the eyelets for any other purpose could result in the vehicle being damaged.
Tiedown Hooks
1. Remove the tiedown eyelet and the lug wrench from the luggage compartment .
2. Wrap a flathead screwdriver or similar tool with a soft cloth to prevent damage to a painted bumper, and open the cap located on the front or rear bumper.
Front
Rear
CAUTION
Do not use excessive force as it may damage the cap or scratch the painted bumper surface.
NOTE
Remove the cap completely and store it so as not to lose it.
3. Securely install the tiedown eyelet using the lug wrench.
Front
Rear
4. Hook the tying rope to the tiedown eyelet.
Front
Rear
CAUTION
If the tiedown eyelet is not securely tightened, it may loosen or disengage from the bumper when tying the vehicle. Make sure that the tiedown eyelet is securely tightened to the bumper.
Towing Description
We recommend that towing be done only by an Authorized Mazda Dealer or a commercial
tow-truck service.
Proper lifting and towing are necessary to prevent damage to the vehicle.
Particularly when t ...
Recreational Towing
An example of “recreational towing” is towing your vehicle behind a motorhome.
The transaxle is not designed for towing this vehicle on all 4 wheels.
When doing recreational towing refer to “T ...
Other materials:
Airflow Mode Actuator [Full Auto Air Conditioner]
Purpose
The airflow mode actuator moves the mode door in the A/C unit to switch the
air vent.
Function
Door open/close function
The airflow mode actuator drives the motor based on the signal from the climate
control unit and moves the mode door to the VENT, BI-LEVEL, HEAT, ...
Wheel Hub Component Removal/Installation [Awd]
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor connector (body sid ...
Engine Oil Level Inspection
1. Position the vehicle on level ground.
2. Warm up the engine.
3. Stop the engine and allow at least 5 min before continuing.
4. Remove the dipstick, wipe it cleanly, and reinstall it fully.
5. Remove the dipstick and verify that the oil level is between the F and L marks
on the dipstick. ...
