Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: PID/Data Monitor Inspection [Start Stop Unit]

Mazda CX-5 Service & Repair Manual / Engine / Control / PID/Data Monitor Inspection [Start Stop Unit]

1. Connect the M-MDS to the DLC?2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

3. Select the applicable PID from the PID table.

4. Verify the PID data according to the directions on the screen.

NOTE:

PID/Data Monitor Inspection [Standard Deployment Control System]
1. Connect the M-MDS to the DLC?2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modulesâ ...

PID/Data Monitor Inspection [Two Step Deployment Control System]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modulesâ ...

Other materials:

Center Pillar Removal [Panel Replacement]
Symbol Mark Removal Procedure CAUTION: Remove the curtain air bag module to prevent damage before servicing. Front-side Rear-side CAUTION: Avoid cutting with a blowtorch or similar tools as the insulator (shaded area) is flammable. 1. Rough cut the ...

Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. B-pillar lower trim. b. Front seat belt adjusting cover. c. Front seat belt upper anchor installation bolt. d. B-pillar upper trim. e. Trunk board. f. Trunk end trim. g. Trunk side trim. h. D-pillar trim. ...

Seat Weight Sensor Control Module Removal/Installation [Two Step Deployment Control System]
CAUTION: When the seat weight sensor control module is replaced with a new one, perform the seat weight sensor calibration using the M?MDS.. 1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Disconnect the connectors. ...

© 2016-2026 Copyright www.mcx5.org