Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Glass Antenna

Purpose, Function

Construction


Fail-safe

Front Power Window Regulator Removal/Installation
1. Perform the front door glass preparation.. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inner garnish. b. Front door trim. c. Front door glass. d. Front ...

Glass Antenna Inspection
1. Disconnect the negative battery cable.. 2. Partially peel back the seaming welt. 3. Remove the liftgate upper trim.. 4. Disconnect antenna feeder No.3 connector.. 5. Visually inspect the gl ...

Other materials:

A/C Unit
Outline The A/C unit which integrates the cooling and heater units has been adopted. Construction The A/C unit consists of the following parts. Operation Air Mix Door Operation The air mix door, installed in the A/C unit, controls HOT or COLD position, depend ...

Forced Ignition On
NOTE: In order to perform a forced ignition ON, the M-MDS is necessary. If the servicing is being done outside of an Authorized Mazda dealership, contact an Authorized Mazda dealership for instructions. The forced ignition ON procedure forces a power supply to each part when ...

Transfer Removal/Installation [Fw6 Ax EL]
CAUTION: Performing the following procedures without first removing the front ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, disconnect the front ABS wheel-speed sensor (axle side) and ...

© 2016-2026 Copyright www.mcx5.org