Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Air Intake Actuator Inspection [Manual Air Conditioner]

Mazda CX-5 Service & Repair Manual / Engine / Intake / Air Intake Actuator Inspection [Manual Air Conditioner]

1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table.



Terminal

Air intake actuator operation

B

C

B+

Ground

FRESH > RECIRCULATE

Ground

B+

RECIRCULATE > FRESH


Air Intake Actuator Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. ...

Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the glove compartment.. 3. Disconnect the air intake actuator connector. 4. Remove the screw, then remove the air intake actuator. 5. I ...

Other materials:

Blind Spot Monitoring (Bsm) Off Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the BSM OFF switch.. 3. Verify that the resistance between BSM OFF switches B and C is as indicated in the table. If the resistance cannot be verified as indicated in the table, replace the cluster switch. 4. Apply batte ...

Steering Gear And Linkage Disassembly
CAUTION: To prevent damage to the steering gear, secure it to the vise using a copper plate or clean cloth. 1. Disassemble in the order indicated in the figure. 1 Dust cover 2 O-ring 3 Tie-rod end ...

Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the trunk board.. 2. Remove the trunk end trim.. 3. Remove the rear scuff plate.. 4. Remove the trunk side trim.. 5. Disconnect the rear ABS wheel-speed sensor connector. 6. Press the rear ABS wheel-speed sensor tabs and press out the sensor toward the outside of the vehicl ...

© 2016-2026 Copyright www.mcx5.org