Mazda CX-5 Service & Repair Manual: Air Bag System [Standard Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Air Bag System [Standard Deployment Control System]

Outline

The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag system will not have the designed effect if the seat belts are not worn properly.
The air bag system is composed of the following parts:


Item	Outline
SAS control module	A yaw rate sensor and a low-G sensor has been added. Recognizes actually equipped air bag module or pre-tensioner seat belt based on module configuration.
Crash zone sensor	Detects degree of impact, converts to an electrical signal, and sends the signal to the SAS control module.
Side air bag sensor
Driver-side air bag module	Adopted to improve safety in frontal collisions.
Passenger-side air bag module	Adopted to improve safety in frontal collisions.
Side air bag module	Chest-protection type side air bag module is used in accordance with the adoption of the curtain air bag module.
Curtain air bag module	Adopted to improve safety in lateral collisions.
Pre-tensioner seat belt	Gear-type pre-tensioner seat belt has been adopted.
Air bag system warning light	LED has been adopted.

Structural View

Wiring Diagram

Air Bag System Warning Light [Two Step Deployment Control System]

Purpose The air bag system warning light notifies the driver of a malfunction in the SRS air bag system. Function If a malfunction occurs in the SRS air bag system, the air bag ...

Air Bag System [Two Step Deployment Control System]

Outline The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag system will not have the designed effect if the seat belts are not ...

Other materials:

Starter Inspection [Skyactiv G 2.0]
On-vehicle Inspection 1. Verify that the battery is fully charged. 2. The starter is normal if it rotates smoothly and without any noise when the engine is cranked. If the starter does not operate, inspect the following: Remove the starter, and inspect the starter unit. ...

Brake Fluid Air Bleeding
CAUTION: Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If it is spilled, wipe it off immediately. NOTE: Keep the fluid level in the brake fluid reserve tank at 3/4 full or more during the air bleeding. Begin air bleedin ...

Center Accessory Socket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the upper console.. 3. Insert a tape-wrapped flathead screwdriver into the gap between the cap tab and socket. 4. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, press the center accessory socket ...