Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Vacuum Hose Removal/Installation

Mazda CX-5 Service & Repair Manual / Brakes / General / Vacuum Hose Removal/Installation

1. Pinch open the clamp using pliers and disconnect the vacuum hose.


2. Pinch open the clamp using pliers and disconnect the vacuum hose.


3. Remove the vacuum hose.

4. Install in the reverse order of removal.

R 3 5 Brake [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The R-3-5 brake operates in 3GR, 5GR and in reverse to lock the reduction internal gear against rotation. Construction The R-3-5 brake consists of the following ...

Vacuum Line Inspection
1. Remove the vacuum hose.. 2. Verify that air can be blown from the power brake unit side of the vacuum hose towards the vacuum pump side, and that air cannot be blown in the opposite direction ...

Other materials:

Blind Spot Monitoring (Bsm) Control Module
Purpose Controls the blind spot monitoring (BSM) system. Function The BSM control module emits microwaves to detect an oncoming vehicle's position and speed information via the reflected microwaves. The BSM system is controlled based on the detected vehicle positio ...

Side Sill Panel Installation [Panel Replacement]
Symbol Mark Installation Procedure Side sill (front side) 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure ...

Relay And Fuse Block Removal/Installation
1. Remove the battery tray.. 2. Remove the air cleaner case.. 3. While pressing the relay and fuse block upper cover tab in the direction of the arrow (1) shown in the figure, lift up the relay and fuse block upper cover in the direction of the arrow (2) to detach the relay and fuse block up ...

© 2016-2026 Copyright www.mcx5.org