Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Theft Deterrent Horn Inspection

Mazda CX-5 Service & Repair Manual / Body / Horn / Theft Deterrent Horn Inspection

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Trunk end trim.

b. Rear scuff plate (RH).

c. Trunk side trim (RH).

d. Theft-deterrent horn.

3. Apply battery positive voltage to horn terminal A, and connect the horn retaining bolt to ground as shown in the figure, and then verify that the horn sounds.


Horn Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the connector. 4. Remove the bolt. 5. Remove the horn. 6. Install in the reverse order of removal. ...

Theft Deterrent Horn Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk end trim. b. Rear scuff plate (RH). c. Trunk side trim (RH). 3. Disconnect the connector. 4. Remove t ...

Other materials:

Rear Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel?speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel?speed sensor (wheel side) and fix it to an ...

Engine Coolant
Inspecting Coolant Level WARNING Do not use a match or live flame in the engine compartment. DO NOT ADD COOLANT WHEN THE ENGINE IS HOT: A hot engine is dangerous. If the engine has been running, parts of the engine compartment can become very hot. You could be burned. Carefully inspect the e ...

Driver and Front Passenger Occupant Classification System
First, please read “Supplemental Restraint System (SRS) Precautions”  carefully. Driver Seat Slide Position Sensor Your vehicle is equipped with a driver seat slide position sensor as a part of the supplemental restraint system. The sensor is located under the driver seat. The sensor ...

© 2016-2026 Copyright www.mcx5.org