Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Secondary Gear [Fw6 A EL, Fw6 Ax EL]

Purpose/Function

Construction

Reduction Gear
Purpose/ Function The reduction gear transmits the rotation input from the EPS motor, decreasing the rotation speed and increasing the torque simultaneously. Construction The re ...

Selector Lever Inspection
1. Switch the ignition ON (engine off or on). 2. Perform the following procedures to inspect the selector lever. If there is any malfunction, adjust the selector cable.. a. Verify that ...

Other materials:

Intake Air Temperature (Iat) Sensor
IAT Sensor No.1 Purpose/Function Detects the IAT before it passes through the throttle body as basic information for mainly determining the fuel injection amount. Detects the IAT before it passes through the throttle body and inputs it to the PCM as an IAT signal. Constru ...

Heater Hose Removal/Installation
With Water Temperature Sensor 1. Remove the battery.. 2. Drain the engine coolant.. 3. Remove the insulator. 4. Remove the clips and remove the heater hose. 5. Remove the heater hose. 6. Install in the reverse order of the removal. 7. Inspect for engine coolant leaka ...

Knee Bolster Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear console. j. ...

© 2016-2026 Copyright www.mcx5.org