Mazda CX-5 Service & Repair Manual: Negative Battery Cable Disconnection/Connection [Skyactiv G 2.0]
WARNING:
-
Before removing the SRS air bag system-related parts, always disconnect the negative battery cable and wait for 1 min. or more to allow the back-up power supply to deplete its stored power..
Required procedure after negative battery cable disconnection/connection
|
System name |
Conditions after disconnecting the negative battery cable |
Required procedure |
Reference |
||
|
Before disconnecting negative battery cable |
After connecting negative battery cable |
||||
|
Power window system |
Reset to initial setting and auto-function is disabled. |
? |
Perform the power window system initial setting. |
(See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE.) |
|
|
Clock and audio |
Clock display and audio system memory are reset. |
Verify the setting content. |
Set the verified content before disconnecting negative battery cable. |
? |
|
|
Tire pressure monitoring system (TPMS) |
The tire pressure monitoring system detection accuracy decreases. |
? |
Perform the tire pressure monitoring system initialization. |
(See TIRE PRESSURE MONITORING SYSTEM INITIALIZATION PROCEDURE.) |
|
Negative Battery Cable Disconnection
1. Switch the ignition off.
2. Disconnect the negative battery cable.
Negative Battery Cable Connection
CAUTION:
-
When tightening the negative battery cable, tighten it to the specified torque. If it is not tightened to the specified torque, the battery charging/discharging may be affected..
1. Perform services required after connecting the negative battery cable..
Battery [Skyactiv G 2.0]
Purpose, Function
The battery stores electricity generated by the generator. In addition, it
supplies power to electronic devices if necessary.
Construction
The battery is insta ...
Remote Transmitter Battery Voltage Inspection
NOTE:
Because the remote transmitter battery power cannot be determined using the
battery itself, determine by the remote transmitter battery low warning operation
conditions.
Oper ...
Other materials:
Rear Door Trim Removal/Installation
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the
arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin
B.
2. Remove the screw C.
3. Remove the cover D, then remove the screw E.
4. Take the shaded area shown in the figur ...
Rear Side Marker Light Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
3. Move the flathead screwdriver in the direction of the arrow (1) shown in the
figure, pull out the service hole cover, and detach the serv ...
Front Door Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
3. Disconnect the front door speaker connector..
4. Verify that the resistance and continuity between the front door speaker terminals
is as indicated in the table.
...
