Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Magnetic Clutch Inspection [Full Auto Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Magnetic Clutch Inspection [Full Auto Air Conditioner]

1. Connect battery to terminal A of magnetic clutch and ground to A/C compressor body.


2. Verify that the magnetic clutch operates.

Magnetic Clutch Disassembly/Assembly [Manual Air Conditioner]
1. Disassemble in the order indicated in the table. 1 Bolt (See Bolt Removal/Installation Note.) 2 Pressure plate 3 ...

Magnetic Clutch Inspection [Manual Air Conditioner]
1. Connect battery to terminal A of magnetic clutch and ground to A/C compressor body. 2. Verify that the magnetic clutch operates. If there is any malfunction, replace the magnetic cl ...

Other materials:

Not P Position Switch Inspection
NOTE: The not P position switch is built into the selector lever component. 1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Disconnect the selector lever component connector. 4. Verify that the continuity between selector lever component terminals ...

Front Buckle Removal/Installation
Driver-side 1. Disconnect the negative battery cable and wait for 1 min or more.. 2. Remove the front seat.. 3. Disconnect the front buckle connector. 4. Remove the bolt. 5. Remove the front buckle. 6. Install in the reverse order of removal. Passenger-side (with buckle switch) ...

Rear Door Garnish Removal/Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. Front 1. Using a tape-wrapped fastener remover, remove clips A in the direction of arrow (1), (2) shown in the figure. 2. Remove the double-sided adhesive tape in the ...

© 2016-2026 Copyright www.mcx5.org