Purpose
The tire pressure warning alarm warns the user that a tire pressure has decreased or notifies the user that the tire pressure warning alarm has been reset.
Function
If the instrument cluster receives a tire pressure warning alarm request signal sent from the DSC HU/CM via the CAN signal, the tire pressure warning alarm is sounded.
The tire pressure warning alarm sound pattern is as follows: For the conditions in which each alarm pattern sounds, refer to TIRE PRESSURE MONITORING SYSTEM (TPMS).
Tire pressure monitoring system operating
Tire pressure monitoring system initialization
Construction
The tire pressure warning alarm sounds using the buzzer built into the instrument cluster.
Operation
1. The instrument cluster receives (1) the tire pressure warning alarm request signal from the DSC HU/CM.
2. The instrument cluster microcomputer turns the transistor on (2) based on the tire pressure warning alarm request signal.
3. When the transistor turns on, the ground circuit of the alarm is established and the alarm sounds (3).
Fail-safe
Function not equipped.
Center Roof Antenna Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Rear scuff plate.
c. B-pillar lower trim.
d. Front seat belt adjusting cover.
e. Front seat belt upper anchor installation bolt.
f. B-pillar upper trim.
g. Trunk board.
h. Trunk end t ...
Steering Column And Shaft
Purpose/Function
The steering input force, generated when the driver operates the steering
wheel, is transmitted to the steering gear.
Construction
The steering column and shaft consists of the steering column with a built-in
EPS mechanism and the intermediate shaft.
...
Hood Latch And Release Lever Removal/Installation
Hood Latch
1. Open the hood.
2. Disconnect the negative battery cable..
3. Remove the front bumper..
4. Insert a tape-wrapped flathead screwdriver into the position shown in the
figure.
5. Move the tape-wrapped flathead screwdriver in the direction of arrow (1) shown
in the figure t ...