Generator Drive Belt
NOTE:
The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner.
1. Verify that the indicator part of the cast hexagon on the drive belt auto tensioner is within the normal range.

If it exceeds the limit, replace the drive belt..
Water Pump Drive Belt
NOTE:
The water pump drive belt deflection/tension inspection is not necessary with the adoption of the stretch-type water pump drive belt.
1. Visually inspect or feel that there is no wear, damage, or cracking on the inside and sides of the entire the belt.
Even if there is a little wear, damage, or cracking, replace the water pump drive belt..
2. Start the engine to verify that abnormal noise does not occur.
If abnormal noise occurs, replace the water pump drive belt..
Control System [Manual Air Conditioner]
Drive Belt Removal/Installation [Skyactiv G 2.0]Seat Track Position Sensor [Two Step Deployment Control System]
Purpose
The seat track position sensor detects the front and back positions of the
driver seat.
Function
The seat track position sensor converts the seat position into an electrical
signal and sends it to the SAS control module.
Construction
The seat track posi ...
Awd Control Module Configuration
CAUTION:
When performing configuration, it is necessary to read the coupling component
calibration data from the AWD control module before replacing it. Connect the
M-MDS to the vehicle and perform vehicle identification before removing the
AWD control module. The coupling component ...
Liftgate Latch And Lock Actuator Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate lower trim.
3. Disconnect the connector.
4. Remove the bolts.
5. Remove the liftgate latch and lock actuator from the liftgate.
6. Install in t ...