Purpose/Function
Illuminates while the cruise control system is in standby mode to inform the driver that the cruise control system is on standby.
Construction
Built into the instrument cluster.

Operation
Illuminates while the cruise control system is on standby.
The PCM sends a cruise main indicator light (amber) illumination request to the instrument cluster via CAN communication.
Cruise Control System
Cruise Set Indicator Light (Green)Suspension
49 T034 1A0
Coil spring compressor set
49 T028 3A0
Ball joint puller set
49 G033 102
Handle
49 U034 204
Dust boot installer
49 FT01 389
Pr ...
Intake Manifold Vacuum Inspection
1. Disconnect the evaporative hose No.3 (purge solenoid valve side) and install
the vacuum gauge..
2. Verify that the intake air hoses are installed securely.
3. Warm up the engine.
4. Measure the intake manifold vacuum while idling (no load) using the vacuum
gauge.
If not within t ...
Front Crossmember Removal/Installation
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the wiring harness
if it is pulled by mistake. Before performing the following procedures, disconnect
the front ABS wheel-speed sensor wiring ha ...