Purpose/Function
Detects the connection status of the clutch.
Construction
Installed on the clutch pedal.

An ON/OFF type switch has been adopted.
Operation
Inputs the CPP switch on/off signal to the PCM.

The contact point is on and voltage is output when the clutch pedal is engaged, and off when the clutch pedal is not engaged.

Fail-safe
Function not equipped.
Clutch Pedal Position (CPP) Switch Inspection [Skyactiv G 2.0]
Clutch Pedal Position Switch Removal/Installation [C66 M R]Fuel Pump Control Module Inspection
1. Perform the KOEO self-test..
2. Verify that a fuel pump control module related DTC is detected..
If DTCs are detected, repair the malfunctioning part according to the applicable
DTC troubleshooting..
If a DTC is not detected, go to the next step.
3. Inspect the followin ...
Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off.
2. Remove the clips.
3. Set the splash shield out of the way.
4. Disconnect the brake pipe from the LF brake hose.
5. Remove the clip.
6. Remove the LF brake hose from the bracket.
7. Detach the brake pipe from the pipe holder.
8. Install the SST ...
Front Pillar Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...