Mazda CX-5 Service & Repair Manual: Basic System
Outline
-
Integrated A/C unit adopted.
-
Sub-cooling system to multi-flow condenser adopted.
Structural View
Ventilation system
Refrigerant system
Flow Diagram
Ventilation system
A/C unit
Inside the vehicle
|
Display |
CENTER VENT |
SIDE VENT |
FOOT VENT |
FRONT DEFROSTER |
SIDE DEFROSTER |
|
|
Front |
Rear |
|||||
|
A |
B |
C |
D |
E |
F |
|
|
|
|
|
— |
— |
— |
— |
|
|
|
|
|
|
— |
— |
|
|
— |
|
|
|
|
|
|
|
— |
|
|
|
|
|
|
|
— |
|
— |
— |
|
|
Refrigerant system
Airflow Mode Main Link Removal/Installation
Full-auto Air Conditioner
1. The airflow mode main link is installed to the airflow mode actuator. When
removing the airflow mode main link, refer to the airflow mode actuator removal/installation. ...
Blower Unit
Purpose
The blower unit switches between fresh air and recirculated air (FRESH/REC)
and sends airflow into the cabin.
Function
Air is blown by the blower motor in the blower uni ...
Other materials:
Rear Differential Disassembly
WARNING:
The engine stand is equipped with a self-lock mechanism, however, if the
rear differential is in a tilted condition, the self-lock mechanism could become
inoperative. If the rear differential unexpectedly rotates it could cause injury,
therefore do not maintain the rear dif ...
DSC HU/CM Removal/Installation
WARNING:
If the DSC HU/CM configuration is not completed, it could result in an unexpected
accident due to the DSC being inoperative. If the DSC HU/CM is replaced, always
use the automatic configuration function so that the DSC operation conditions
are correct.
If the DSC re ...
M Position Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
The M position switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect the selector lever component connector.
4. Verify that the continuity between selector lever c ...
