Purpose/Function
The automatic transaxle warning light illuminates when the transaxle has malfunction.
Construction
The automatic transaxle warning light is built into the instrument cluster.

Operation
If the transmission has a malfunction, the TCM sends an automatic transaxle warning light illumination request signal to the instrument cluster.

The TCM illuminates the automatic transaxle warning light for approx. 2 s
after the ignition is switched ON to perform a bulb check of the automatic transaxle warning light.
Automatic Transaxle Shift Mechanism [Fw6 A EL, Fw6 Ax EL]
Control Valve Body Removal/Installation [Fw6 A EL, Fw6 Ax EL]Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor
and measure the resistance between passenger compartment temperature sensor terminals
A and B.
If the characteristics of the passenger compartment temperature sensor are
not as shown in the graph, replace t ...
Door Lock Switch Inspection
Driver's Side
1. Disconnect the negative battery cable..
2. Remove the door lock switch..
3. Verify that the continuity is as indicated in the table.
If the continuity is not as indicated in the table, replace the door lock
switch.
Passenger's Side
1. Disconnec ...
Rear Seat Back Trim Removal/Installation
6:4 Split Type
1. Remove the trunk board..
2. Remove the rear seat back..
3. Remove the headrest.
4. Remove the rear seat back frame..
5. Remove the C rings in the order of (1), (2), (3), and (4) shown in the figure,
and remove the rear seat back trim from the rear seat back pad.
CA ...