Mazda CX-5 Service & Repair Manual: Slide Motor Inspection
WARNING:
-
Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual before handling the front seat (side air bag integrated)..
CAUTION:
-
When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean cloth so as not to damage or soil the seat.
NOTE:
-
When removing the front seat from the vehicle or putting it back in, it can be performed smoothly by removing the headrest.
1. Disconnect the negative battery cable and wait for 1 min
..
2. Disconnect the slide motor connector.
3. Apply battery positive voltage to the slide motor terminals and inspect the front seat operation.
-
If not as specified, replace the slide motor..
|
Front seat operation |
Connection |
|
|
B |
D |
|
|
Forward |
GND |
B+ |
|
Backward |
B+ |
GND |
Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]
CAUTION:
When the seat weight sensor is replaced with a new one, perform the seat
weight sensor calibration using the M?MDS..
When replacing the seat weight sensor, replace it t ...
Slide Motor Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual befor ...
Other materials:
Rear Bumper Reinforcement Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear splash shield.
b. Rear combination light.
c. Rear bumper.
3. Remove the hanger rubber in the direction of the arrow (1) shown in the figure.
4. Remove nuts.
CAUTION:
Removing the rear bumper ...
Cylinder Head Gasket
Purpose, Function
The cylinder head gasket is installed between the cylinder head and cylinder
block to prevent leakage of air-fuel mixture, combustion gas, engine oil, and
engine coolant.
Construction
A four-layer type metal gasket has been adopted for the cylinder head ga ...
Essential Information
Introduction
Be extremely careful and prevent injury to yourself and others or damage to your
vehicle when using this manual for inspection and maintenance.
If you are unsure about any procedure it describes, we strongly urge you to have
a reliable and qualified service shop perform the work ...
