Mazda CX-5 Service & Repair Manual: Shift Position Indicator Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The shift position indicator light indicates the selector lever position.
Construction
-
The shift position indicator light is built into the instrument cluster.
Operation
-
The TCM sends a shift position indicator light illumination request signal to the instrument cluster via CAN based on the signal from the integrated transaxle range sensor signal received via CAN.
Security Indicator Light
Purpose
Notifies the driver that the immobilizer system is operating.
Function
If a malfunction is detected in the immobilizer system, the DTC can be verified
by the flashing pa ...
Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling
the TCS control at driver discretion.
The TCS OFF indicator light, built ...
Other materials:
Washer Fluid Level Sensor Inspection
1. Disconnect the negative battery cable..
2. Set the front over fender aside..
3. Set the mudguard (RH) aside..
4. Remove the front bumper..
5. Inspect for continuity according to washer fluid level between the washer
fluid-level sensor terminals.
If not as indicated in th ...
PCM Configuration (Using Read/Write Function)
NOTE:
When performing configuration, it is necessary to read the vehicle specification
information from the PCM before replacing it. Connect the M-MDS to the vehicle
and perform vehicle identification before removing the PCM. The vehicle specification
information is temporarily stor ...
Front Fog Light Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the mudguard screws.
3. Disconnect the connector.
4. Rotate the front fog light bulb in the direction of the arrow (1) shown in
the figure and remove it from the front fog light in the direction of the arrow
(2) shown in the figu ...
