Chevrolet Spark manuals

Mazda CX-5 Owners Manual: Hazard Warning Flasher

The hazard warning lights should always be used when you stop on or near a roadway in an emergency.

The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it.


Depress the hazard warning flasher and all the turn signals will flash. The hazard warning indicator lights in the instrument cluster flash simultaneously.

NOTE

• The turn signals do not work when the hazard warning lights are on.

• Check local regulations about the use of hazard warning lights while the vehicle is being towed to verify that it is not in violation of the law.

Horn
To sound the horn, press the mark on the steering wheel. ...

HomeLink Wireless Control System
NOTE HomeLink and HomeLink house are registered trademarks of Johnson Controls. The HomeLink system replaces up to 3 hand-held transmitters with a single builtin component in the auto-dimming mirr ...

Other materials:

Front Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the front scuff plate in the direction of the arrow (1) shown in the figure, then detach the hook B, clip C, and pin D while pulling in the direction of the arrow (2). 2. Take the shaded area shown in the figure, detach ta ...

Rear Combination Light Removal/Installation
NOTE: Fogging or condensation on the inside of the rear combination lights may occur due to a natural phenomenon occurring as a result of a temperature difference between the interior and exterior of the combination lights. However, it has no effect on the light performance because ...

Refrigerant Pressure Check
NOTE: Measure the refrigerant pressure after approx.10 min have elapsed from engine start. 1. Install the manifold gauge.. 2. Start the engine and warm it up. 3. Set the fan speed MAX HI. 4. Turn the A/C switch on. 5. Set to RECIRCULATE mode. 6. Set the temperature control ...

© 2016-2026 Copyright www.mcx5.org