Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Sunroof Switch Removal/Installation

NOTE: The sunroof switch is together with the front map light. 1. Disconnect the negative battery cable.. 2. Remove the front map light.. 3. Install in the reverse order of removal. ...

Sunroof Switch Inspection

1. Disconnect the negative battery cable.. 2. Remove the front map light.. 3. Verify that the continuity between the sunroof switch terminals is as indicated in the table. If not as ...

Other materials:

Seat Weight Sensor Inspection [Two Step Deployment Control System]
CAUTION: If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS. Removal of the passenger-side seat Loosening and retightening of passenger’s seat fixing bolts Or, the vehicle is involved in a collision ...

Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction If the control valve body and oil pressure switch are replaced, always perform the initial learning. If the initial learning is not completed, engine rev-up may occur or shift shock may increase. DTC P06B8:00 is displayed while the initial learning has not been implement ...

Front Side Frame (Partial Cutting) Installation [Panel Replacement]
Symbol Mark Installation Procedure CAUTION: The cut and joint area indicates the maximum size range of the installation position. 1. Drill holes for the plug welding before installing the new parts. 2. When installing the new parts, trial-fit new and existing parts, and then ...