Mazda CX-5 Service & Repair Manual: Rear Wiper Motor Inspection
1. Disconnect the negative battery cable..
2. Open the liftgate.
3. Remove the following parts:
a. Rear wiper arm and blade.
b. Liftgate upper trim.
c. Liftgate side trim.
d. Liftgate recess.
e. Liftgate lower trim.
4. Remove the rear wiper motor connector.
Rear Wiper Motor Operation Inspection
1. Apply battery positive voltage to rear wiper motor connector terminal B, and connect terminal A to the ground.
2. Verify that the rear wiper motor operates normally.
-
If there is any malfunction, replace the rear wiper motor..
Auto-stop Operation Inspection
1. Apply battery positive voltage to rear wiper motor connector terminal B, and connect terminals A and C to the ground.
2. Disconnect the ground from rear wiper motor connector terminal A while the rear wiper is operating.
3. After the windshield wiper motor auto-stop operation, verify that it stops at the park position.
-
If there is any malfunction, replace the rear wiper motor..
Rear Wiper Arm And Blade Removal/Installation
Rear Wiper Arm
1. Pull the cap in the direction of the arrows (1) shown in the figure and remove
it in the direction of the arrow (2) with tabs A, B released.
2. Remove the nut with the rear ...
Rear Wiper Motor Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear wiper arm and blade.
b. Liftgate upper trim.
c. Liftgate side trim.
d. Liftgate recess.
e. Liftgate lower ...
Other materials:
Heater Core
Purpose
The heater core heats passing air.
Function
A portion of the engine coolant is taken into the heater core to heat the
air passing through the heater core.
Construction
The heater core consists of a tube which passes engine coolant, and the heat
ra ...
Front Bumper Removal/Installation
CAUTION:
Affix the protective tape to the position (vehicle body side) shown in the
figure to prevent scratches and damage.
1. Disconnect the negative battery cable..
2. Remove fasteners A.
3. Pull the front over fender in the direction of the arrow shown in the figure ...
High Mount Brake Light Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the liftgate upper trim..
3. Remove the rear spoiler..
4. Disconnect the connector.
5. While pressing the high-mount brake light tab in the direction of arrow (1)
shown in the figure, press the high-mount brake light in the direction ...
