Purpose
Each door glass except for the driver-side can be opened/closed with occupant seated in the cabin using the power window subswitch.
Function
Manual switch
The power window subswitch switches the contact point according to the switch operation and switches the circuit to the power window motor.
Construction
The power window subswitch is equipped on the front passenger side and the rear passenger sides.

Operation
Manual operation (Example: close operation)
1. When the power window subswitch is turned to the manual close position (1), a manual close signal is sent to the power window motor.(2)

Fail-safe
Function not equipped
Power Window Regulator
Power Window Subswitch InspectionVentilator Grille Removal/Installation
Side Ventilator Grille
Driver-side
1. Disconnect the negative battery cable..
2. Remove the switch panel..
3. Insert your hand from the area where the switch panel was installed, remove
the side ventilator grille in the direction of the arrow shown in the figure while
detaching hooks A.
...
Discharge Headlight Bulb
Purpose, Function
Charges the internal metallic element and emits white light resembling sunlight.
Construction
A mercury-free bulb has been adopted for the discharge headlight bulb.
The discharge headlight bulb is assembled to the front combination light.
The dis ...
Rear Drive Shaft Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel?speed
sensor may possibly cause an open circuit in the harness if it is pulled by
mistake. Before performing the following procedures, remove the ABS wheel?speed
sensor (wheel side) and fix it to an ...