Mazda CX-5 Service & Repair Manual: On/Off Solenoid [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The on/off solenoid performs switching of the shift valve in the control valve body according to the vehicle conditions.
Construction
-
The on/off solenoid is installed to the solenoid control valve body.
-
The on/off solenoid is a normal open-type on/off solenoid.
Operation
Non-energization (OFF)
-
When the on/off solenoid is off, the supply port in the solenoid opens. As a result, hydraulic pressure is supplied to operate the shift valve.
Energized (ON)
-
When the on/off solenoid is on, the drain port in the solenoid opens. As a result, hydraulic pressure which operates the shift valve is drained.
On/Off Solenoid Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait
until they are cool.
Always wear protective eye wear when using the air compressor. If the ...
One Way Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The one-way clutch operates in 1GR and suppresses the counterclockwise rotation
of the front internal gear (as viewed from torque converter side).
Construction
...
Other materials:
Clutch Fluid Leakage Inspection [C66 M R]
CAUTION:
Do not allow clutch fluid to get on a painted surface. Clutch fluid contains
properties which can dissolve the paint. If clutch fluid gets on a painted surface,
wash it off with water immediately and wipe the area off completely.
1. Verify reserve tank cap is on tight.
...
Rear Heat Duct Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Decoration panel.
b. Shift lever knob (MTX).
c. Front console box.
d. Shift panel.
e. Upper panel.
f. Rear console.
g. Side wall.
h. Front console.
i. Front scuff plate.
j. Front side trim.
k. Joint ...
Procedure [Plastic Body Parts]
Repair of polypropylene bumpers having damage that has reached the surface of
the polypropylene and are too serious to be restored by painting only.
1. Cut the rough edges around the damage with a knife to make it smooth. Sand
the area with a sander to make an angle of about 45°.
2. ...
