Purpose
Outputs a request signal and specifies the remote transmitter location.
Function
The keyless antenna outputs request signals to the inside and outside of the vehicle based on the signals from the LF control unit.
Construction, Operation
The antennas for request signal output form the request signal output range at 5 locations.

Request signal output range
The keyless antennas for the vehicle exterior (driver-side, passenger-side, rear) form the request signal output area in the range of an approx. 80 cm {31 in}
radius from each location and communicate with the advanced key.
The keyless antennas for the vehicle interior (front, rear) form the output range inside the vehicle.

Fail-safe
Function not equipped.
Keyless Antenna Removal/Installation
Keyless Antenna [Keyless Entry System]Quick Release Connector Removal/Installation
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin and eyes. To prevent this, always complete the “Fuel
Line Safety Procedure”, while referring ...
Rear Door Speaker Removal/Installation
Without Bose®
NOTE:
If the procedure is performed while holding the front door speaker cone,
it could deform the cone causing a malfunction. Therefore, perform the procedure
while holding any part other than the cone.
1. Disconnect the negative battery cable..
2. Remove the r ...
Front Beltline Molding Removal/Installation
CAUTION:
Affix protective tape to the position shown in the figure.
1. Fully open the front door glass.
2. Insert a tape-wrapped flathead screwdriver and then detach clips A in the
direction of arrow (1) shown in the figure.
3. Pull up the front side of front beltline molding ...