Mazda CX-5 Service & Repair Manual: Horn
Purpose, Function
-
The horn sounds according to the horn switch operation.
Construction
-
Installed to the inside of the front grille.
-
The diaphragm is vibrated to apply vibration to the air and produce sound.
Operation
1. When the horn switch turns on (1), the horn relay turns on (2).
2. When the horn relay turns on, the horn sounds.
Fail-safe
-
Function not equipped.
Horn
...
Horn Inspection
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Remove the horn..
4. Apply battery positive voltage to horn terminal A, and connect the horn retaining
bolt to ground ...
Other materials:
Vacuum Pump Inspection
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the
vacuum pump..
2. Install the vacuum gauge as shown in the figure, then check the vacuum.
3. Warn up the engine.
If the pressure is less than the specification, inspect for the following.
Malf ...
Discharge Headlight Service Warnings
Discharge Headlight Service Warnings
When replacing a discharge headlight bulb, performing the servicing with
the negative battery cable connected or in a wet work area could result in electrocution.
When replacing a discharge headlight bulb, perform the servicing under the following
...
Front Stabilizer Removal/Installation
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the wiring harness
if it is pulled by mistake. Before performing the following procedures, disconnect
the front ABS wheel-speed sensor wiring ...
