Mazda CX-5 Service & Repair Manual: Accessory Socket
Purpose
-
By inserting the plug of an electrical device, 12 V (maximum 120 W) of power is supplied enabling use of the electrical device in the vehicle.
Function
Front accessory socket
-
When the ignition is switched to ACC or ON (engine off or on), 12 V (maximum 120 W) of power is supplied.
Center accessory socket, rear accessory socket
-
12 V (maximum 120 W) of power is supplied constantly.
Construction
-
A cap is installed to prevent penetration of foreign matter in the socket such as dust.
-
A front accessory socket is installed to the front console.
-
A center accessory socket is installed inside the rear console.
-
A rear accessory socket is installed to the trunk side trim (RH).
Operation
Front accessory socket
1. When the ignition is switched to ACC or ON (engine on or off), power is supplied constantly.
Center accessory socket, rear accessory socket
1. Power is supplied constantly.
Fail-safe
-
Function not equipped.
Power Sockets
...
Center Accessory Socket Inspection
1. Remove the center accessory socket..
2. Connect the tester probe to the position shown in the figure and verify that
there is continuity.
If it cannot be verified, replace the cente ...
Other materials:
Floor Mat
WARNING
Make sure the floor mats are hooked on the retention pins to prevent them from
bunching up under the foot pedals:
Using a floor mat that is not secured is dangerous as it will interfere with
the accelerator and brake pedal operation, which could result in an accident.
Do not install t ...
Upper Panel Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front console box.
b. Shift lever knob (MTX).
c. Shift panel.
3. Open the console lid.
4. Remove the button, then open the fastener.
5. Take the shaded area shown in the figure, and remove the upper panel ...
DRL (Daytime Running Light) Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Disconnect the connector.
3. Rotate the DRL bulb in the direction of the arrow (1) shown in the figure
and remove it from the front combination light in the direction of the arrow (2)
shown in the figure.
4. Install in the reverse order ...
